FixVault
Home › Mitsubishi › 2014 › Lancer Evolution MR › Repair and Diagnosis › External Pages › Different car › Section 65 (Cruise Control System - With Diagnostics) › Cruise Control System Diagnosis › Data List Reference Table

Data List Reference Table

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Road test always needs two people: one driver and one observer.
  • When shifting the selector lever to "D" position the brakes should be applied so that the vehicle does not move forward.
Item No. Check item Check condition Normal condition
04 Vehicle speed signal Road test the vehicle. The speedometer and scan tool (M.U.T.-III) display the same value.
11 Accelerator pedal position sensor (main) Ignition switch: "ON" Release the accelerator pedal 900 - 1,100 mV
Depress the accelerator pedal gradually Increases in response to the pedal depression stroke
Depress the accelerator pedal fully 4,000 mV or more
13 Throttle position sensor (main)
  • Remove the intake air hose at the throttle body
  • Disconnect the throttle position sensor connector, and then connect terminal numbers No. 3, No. 4, No. 5 and No. 6 with the use of the special tool: MB991658.
  • Ignition switch: "ON"
 Fully close the throttle valve with your finger 300 - 700 mV
Fully open the throttle valve with your finger 4,000 mV or more
Engine: warming up, idling No load 500 - 660 mV
A/C switch: "OFF" → "ON" Voltage rises
Shift lever: "N" → "D"
57 Cancel code Ignition switch: "ON" The cancel code, which is stored when the cruise control system was cancelled at the last time, is stored again.
74 Stoplight switch (for stoplight circuit) Ignition switch: "ON" Brake pedal: Depressed ON
Brake pedal: Released OFF
75 Cruise control switches (CANCEL switch) Ignition switch: "ON" CANCEL switch: Pressed ON
CANCEL switch: Released OFF
81 Cruise control operation Cruise control: active ON
Cruise control: Inactive OFF
86 Cruise control switches (Cruise control ON/OFF switch) Ignition switch: "ON" Cruise control ON/OFF switch: Pressed ON
Cruise control ON/OFF switch: Pressed again OFF
88 Transmission range switch Ignition switch: "ON" Selector lever: "N" or "P" position ON
Selector lever: Other than "N" or "P" position OFF
89 Brake switch (for cruise control circuit) Ignition switch: "ON" Brake pedal: Depressed ON
Brake pedal: Released OFF
91 Cruise control switches (RES + switch) Ignition switch: "ON" RES + switch: Pressed ON
RES + switch: Released OFF
92 Cruise control switches (SET - switch) Ignition switch: "ON" SET - switch: Pressed ON
SET - switch: Released OFF
About FixVault