Cruise Control Switch Check

Remove the cruise control switch (Refer to CRUISE CONTROL SWITCH .)

Measure the resistance between terminal number 2 and terminal number 3 when each of the "CRUISE ON/OFF", "CANCEL", "SET-" and "RES+" switches is pressed. If the values measured at the time each switch is pressed correspond to those in the table below, the resistance values are correct.

Fig 1: Identifying Cruise Control System Connector Terminals

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Terminal connector of tester	Switch position	Specified condition
2 - 3	All switches are released.	Open circuit
	"CRUISE ON/OFF" switch is pressed	Continuity (less than 2 ohms)
	"CANCEL" switch is pressed	203 - 207 Ω
	"SET-" switch is pressed	611 - 623 Ω
	"RES+" switch is pressed	1839 - 1875 Ω

Check that the cruise control switch illuminates when a positive battery terminal is connected to the connector terminal number 4, and terminal number 1 is grounded.