FixVault

The System Is Normal

WARNING: This page is about a different variant/trim than selected.
Item No. Display on M.U.T.-III Check conditions Normal condition
1 AWC control mode (AWD control mode) AWD is selected (displayed on multi information display). 4WD ECO
4WD AUTO
4WD LOCK
5 Center coupling current Perform a test run of the vehicle. 0 - 3 A
6 AWC protection control (AWD protection control) Correct OFF
Malfunction ON
7 AWC system fail (AWD system fail) Correct OFF
Malfunction ON
8 Steering angle sensor Steering wheel steered Within a predetermined steering angle
9 Steering angle speed Steering wheel: Without steering wheel operation 0 deg/s
Steering wheel: With steering wheel operation Changes depending on the turning speed.
10 Steering angle sensor (status) Normal Correct
Faulty Malfunction
Neutral point not learned Neutral not learned
Neutral point not learned or failed Neutral not learned and Malfunction
11 Accelerator position Release the accelerator pedal Approximately 0%
Depress the accelerator pedal 0 - 100%
Accelerator pedal fully opened Approximately 100%
12 Engine speed Idling and test run 0 - Maximum engine speed
13 A/T gear position Gear range: P P
Gear range: R R
Gear range: N N
Gear range: 1st 1st
Gear range: 2nd 2nd
Gear range: 3rd 3rd
Gear range: 4th 4th
Gear range: 5th 5th
Gear range: 6th 6th
Gear range: 7th 7th
14 FL wheel speed (raw value) -- (reference because of r/min) -
15 FR wheel speed (raw value)
16 RL wheel speed (raw value)
17 RR wheel speed (raw value)
18 FL wheel speed sensor Perform a test run of the vehicle. Nearly the same as the speedometer display
19 FR wheel speed sensor
20 RL wheel speed sensor
21 RR wheel speed sensor
22 Yaw rate sensor When the vehicle is stationary Approximately 0 deg/s
Perform a test run of the vehicle. -90 - 90 deg/s
23 Lateral G sensor Vehicle is stopped (horizontal state). Approximately 0 m/s2
Perform a test run of the vehicle. -10.24 - 10.08 m/s2
24 Longitudinal G sensor Vehicle is stopped (horizontal state). Approximately 0 m/s2
Perform a test run of the vehicle. -10.24 - 10.08 m/s2
25 ASC status Ignition switch: ON ASC ON
ASC OFF
ASC, S-AWC OFF
ASC Fail
28 Brake switch (CAN input) Brake pedal: Depressed ON
Brake pedal: Released OFF
29 Parking brake SW (CAN input) Parking brake lever: Pulled ON
Parking brake lever: Released OFF
30 Ignition SW (CAN input) Ignition switch: ACC ACC
Ignition switch: ON ON
Ignition switch: START START
31 Battery voltage (CAN input) Ignition switch: ON 6 - 17 V
32 IOD fuse (CAN input) Fuse inserted ON
Fuse removed OFF
33 Odometer (CAN input) Ignition switch: ON 0 - 1, 677, 721.4 km
(0.00 - 10, 427, 106.2 mile)
34 Ambient temperature (CAN input) Ignition switch: ON -30 °C - 85 °C
(-22 °F - 185 °F)
35 Ignition off time (CAN input) After ignition switch: OFF for one minute or more, ignition switch: ON 0 - 254 min
38 IG1 Ignition switch: ON ON
Ignition switch: OFF OFF
39 ECU power supply voltage Ignition switch: ON 10 - 18.75 V
40 Output load voltage Ignition switch: ON 10 - 18.75 V
41 Mode SW Drive mode selector: OFF OFF
Drive mode selector: ON ON
44 SAS (adjusted value) Ignition switch: ON -15 - 15 deg
45 Chassis Number writing counter Ignition switch: ON Writing count
46 Chassis Number (original) lock Ignition switch: ON Locked Lock
Unlocked Unlock
47 Mileage counter Ignition switch: ON Counter value
48 Coding counter Ignition switch: ON 0 - 255 times