FixVault
Home › Mitsubishi › 2019 › Outlander LE, AWD › Repair and Diagnosis › External Pages › Different car › Section 133 (Electronic Control Modules (Service Information)) › Module, Hands Free Liftgate › Removal › Module

Module, Hands Free Liftgate: Removal: Module

WARNING: This page is about a different car, the 2020 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the rear bumper lower fascia. Refer to FASCIA, REAR, LOWER, REMOVAL .
    GC0186771Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the wire harness connectors (1) from the Hands Free Entry (HFE) liftgate module (3).
  4. Remove the fastener (2) securing the HFE liftgate module (3) to the HFE sensor bracket.
  5. Remove the HFE liftgate module from the vehicle.
About FixVault