Section 14 (Combination Meter)
WARNING: This page is about a different car, the 2017 Mitsubishi Mirage G4. However, it is still accessible from the selected car via links, so may be relevant.
- Service Specifications
- Special Tools
- Diagnosis
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- DTC B1200: Odometer failure
- DTC B1201: Fuel information problem
- DTC B1209: Test mode
- DTC B2463: Rheostat switch sticking
- DTC U0100: Engine CAN timeout
- DTC U0101: T/M CAN timeout
- DTC U0121: ABS/ASC CAN timeout
- DTC U0131: EPS CAN timeout
- DTC U0141: ETACS CAN timeout
- DTC U0151: SRS-ABG CAN timeout
- DTC U0154: OCM CAN timeout
- DTC U0168: WCM/F.A.S.T. CAN timeout
- DTC U1000: OSS/F.A.S.T._OSS CAN timeout
- DTC U1110: A/C CAN timeout/Not equipped
- DTC U1190: No receive fault detect signal
- DTC U1195: Coding not completed
- Trouble Symptom Chart
- Symptom Procedures
- Inspection Procedure 1: Power supply circuit check; Inspection Procedure 2: The odometer and the trip meter are not displayed; Inspection Procedure 3: No needle meters work; Inspection Procedure 4: If the ignition switch is turned to the "ON" position, the indicator and warning lights do not illuminate normally
- Inspection Procedure 5: The speedometer does not work (The other meters work)
- Inspection Procedure 6: The tachometer does not work (the other meters work)
- Inspection Procedure 7: Tone alarm does not sound normally
- Notes
- Technical Description (Comment)
- Notes
- OSS-related malfunction warning tone alarm (vehicles with KOS)
- Engine switch reminder tone alarm (vehicles with KOS)
- Ignition key reminder tone alarm function (vehicles without KOS)
- Light reminder tone alarm
- Door-ajar warning tone alarm
- Freeze warning tone alarm
- Parking brake reminder tone alarm
- Multi-information display switch operation tone alarm
- Turn-signal light tone alarm
- ETACS-ECU function customize tone alarm
- Troubleshooting Hints
- Diagnosis
- Inspection Procedure 8: Fuel gauge does not work (the other meters work)
- Inspection Procedure 9: The combination meter light does not illuminate normally or the multi-information display is not displayed normally
- Inspection Procedure 10: The multi-information display screen cannot be changed with the operation of the multi-information display switch
- Inspection Procedure 11: Parking brake reminder tone alarm does not sound; Inspection Procedure 12: Brake warning light does not illuminate
- Inspection Procedure 13: Ambient temperature sensor does not work
- Inspection Procedure 14: Seat belt reminder function does not work normally
- Inspection Procedure 15: Washer fluid level warning light does not illuminate.
- Data List
- Actuator Test Table
- Special Function Table
- Check At Combination Meter Terminals
- On-Vehicle Service
- Speedometer Check
- Tachometer Check
- Fuel Level Sensor Check
- Service Reminder Function Set
- Combination Meter