Diagnostic Trouble Code Chart
CAUTION:
- During troubleshooting, a DTC associated with other system may be stored when the ignition switch is turned on with connector(s) disconnected. On completion, check all systems for DTCs. If DTCs are stored, erase them all.
- When the combination meter is required to be replaced as a result of the troubleshooting, the current driving distance and number of elapsed days to be used for service reminder function must be entered into the meter after the replacement. Therefore, read "Integrated mileage for reminder," "Integrated days for reminder," "Mileage until Extra reminder," "Months until Extra reminder," and "Current Schedule" from the meter before the replacement using the special function of scan tool (M.U.T.-III), and note them. For the operation method of scan tool (M.U.T.-III), refer to SERVICE REMINDER FUNCTION SET
. If "Integrated mileage for reminder" or "Integrated days for reminder" cannot be read by the scan tool (M.U.T.-III), follow the method described below.
- For the driving distance for check warning, use the driving distance displayed on the multi information display.
- For the elapsed days for check warning, calculate the number of elapsed days from the delivery date to the customer (service remainder function start date) and current date.
| DTC No. | Diagnostic item | Reference |
|---|---|---|
| B1200 | Odometer failure | DIAGNOSTIC TROUBLE CODE PROCEDURES |
| B1201 | Fuel information problem | DIAGNOSTIC TROUBLE CODE PROCEDURES |
| B1209 | Test mode | DTC B1209: TEST MODE |
| B2463 | Rheostat switch sticking | DTC B1209: TEST MODE |
| U0100 | Engine CAN timeout | DTC B1209: TEST MODE |
| U0101 | T/M CAN timeout | DTC U0101: T/M CAN TIMEOUT |
| U0121 | ABS/ASC CAN timeout | DTC U0121: ABS/ASC CAN TIMEOUT |
| U0131 | EPS CAN timeout | DTC U0131: EPS CAN TIMEOUT |
| U0141 | ETACS CAN timeout | DTC U0141: ETACS CAN TIMEOUT |
| U0151 | SRS-ABG CAN timeout | DTC U0151: SRS-ABG CAN TIMEOUT |
| U0154 | OCM CAN timeout | DTC U0154: OCM CAN TIMEOUT |
| U0168 | WCM/F.A.S.T. CAN timeout | DTC U0168: WCM/F.A.S.T. CAN TIMEOUT |
| U1000 | OSS/F.A.S.T._OSS CAN timeout | DTC U1000: OSS/F.A.S.T._OSS CAN TIMEOUT |
| U1110 | A/C CAN timeout/Not equipped | DTC U1110: A/C CAN TIMEOUT/NOT EQUIPPED |
| U1190 | No receive fault detect signal | DTC U1190: NO RECEIVE FAULT DETECT SIGNAL |
| U1195 | Coding not completed | DTC U1195: CODING NOT COMPLETED |