FixVault

ETACS Customization

WARNING: This page is about a different car, the 2020 Mitsubishi Outlander PHEV. However, it is still accessible from the selected car via links, so may be relevant.

Using the ETACS system of scan tool (M.U.T.-IIISE), the following functions can be programmed. The programmed information is held even when the battery is disconnected.

Adjustment item (scan tool display) Adjustment item Adjusting content (scan tool display) Adjusting content
Turn power source Adjustment of turn-signal light operation condition ACC or IG1 Operable with ACC or ON position
IG1 Operable with ON position (initial condition)
Comfort flasher With/without comfort flasher function Disable No function
Enable With function (initial condition)
Hazard answer back Adjustment of the number of keyless hazard warning light answer back flashes Lock: 1, Unlock: 2 LOCK: Flashes once, UNLOCK: Flashes twice (initial condition)
Lock: 1, Unlock: 0 LOCK: Flashes once, UNLOCK: No flash
Lock: 0, Unlock: 2 LOCK: No flash, UNLOCK: Flash twice
Lock: 2, Unlock: 1 LOCK: Flash twice, UNLOCK: Flash once
Lock: 2, Unlock: 0 LOCK: Flash twice, UNLOCK: No flash
Lock: 0, Unlock: 1 LOCK: No flash, UNLOCK: Flash once
Lock: 0, Unlock: 0 No function
Front wiper operation Adjustment of the intermittent windshield wiper operation Normal INT Intermittent wiper interval is fixed to 4 seconds.
Variable INT Intermittent wiper interval is calculated only by the wiper volume control.
Speed Sensitive Intermittent wiper interval is calculated according to the intermittent wiper volume control and vehicle speed.
Rain Sensitive Intermittent wiper interval is calculated according to the intermittent wiper volume control and lighting control sensor (initial condition).
Front/rear wiper washer Disabling or enabling washer-linked wiper function Only Washer No function
Washer & Wiper With function: Without delayed finishing wipe function (Initial condition)
With after wipe With function: With delayed finishing wipe function
Intermittent time of rear wiper Adjustment of rear wiper interval 0 sec No wiper interval
4 sec 4 seconds
8 sec 8 seconds (initial condition)
16 sec 16 seconds
Rear wiper Low speed mode Disabling or enabling rear wiper continuous operation Disable No function
Enable With function (initial condition)
Auto fold mirror Electric folding door mirror automatic unfolding function <electric retractable remote controlled door mirrors> Not Auto No synchronized operation
Open Vehicle SPD Vehicle speed-dependent operation
Open/Close by IG Electric motor switch linked operation
OPN/CLS Keyless Keyless entry linked operation (initial condition)
Sensitivity for auto light Lighting control sensor sensitivity (illumination intensity) Level 1 bright High-high ambient brightness
Level 2 bright High ambient brightness
Level 3 Standard ambient brightness (initial condition)
Level 4 dark Low ambient brightness
Level 5 dark Low-low ambient brightness
Dome light delay timer with door Adjustment of interior light delay shutdown time 0 sec 0 second (no delay shutdown time)
7.5 sec 7.5 seconds
15 sec 15 seconds
30 sec 30 seconds (initial condition)
60 sec 60 seconds
120 sec 120 seconds
180 sec 180 seconds
Headlight auto cut customize Adjustment of headlight automatic shutdown function Disable No function
Enable (C-spec.) With function (initial condition)
Interior light auto cut timer Adjustment of interior light automatic shutdown function operation time Disable No function
3 min 3 minutes
30 min 30 minutes (initial condition)
60 min 60 minutes
Auto door unlock Adjustment of the auto door unlock function Disable Without function (initial condition)
Always (Lock pos) With function: Operates when the electric motor switch is moved to the LOCK position.
Door unlock mode Adjustment of power door locks with selective unlocking All Doors Unlock Without function: The first operation of unlock operation by KOS unlocks all doors.
Dr Door Unlock With function: The first operation of unlock operation by KOS unlocks the driver's door only, and the second unlock operation within 2 seconds after that unlocks all doors. (initial condition)
Horn chirp by keyless Horn chirp by keyless entry system Not sound horn No horn answerback function
Lock any time The horn sounds when the lock button of keyless entry transmitter is pressed once.
Lock/auto ON During daytime, while the lighting switch is in the AUTO position, the horn sounds once when the lock is pressed once.
W lock any time The horn sounds when the lock button of keyless entry transmitter is pressed twice. (initial condition)
Buzzer answer back Adjusts the tone alarm answer back function. Not sound buzzer No function
At keyless Sounds when the keyless entry system is activated.
At F.A.S.T.(1) Sounds when KOS is activated (initial condition).
At Both Sounds when the keyless entry system or KOS is activated.
Timer lock timer Timer lock period adjustment 30 sec 30 seconds (initial condition)
60 sec 60 seconds
120 sec 120 seconds
180 sec 180 seconds
Panic alarm switch With/without panic alarm function Disable No function
Enable With function (initial condition)
Duration of horn chirp Horn sounding time during horn answer back Short 0.01 second (initial condition)
Long 0.02 second
F.A.S.T.(1) key detect out from window With/without KOS key exterior detection function Enable No function
Disable With function (initial condition)
F.A.S.T.(1) feature KOS function adjustment Both enable All KOS functions are enabled. (initial condition)
Door Entry enable Only door entry function is enabled.
ENG start enable Only engine starting function is enabled.
Both disable All KOS functions are disabled.
F.A.S.T.(1) unlock disable time Adjusts the door unlock inhibition period after door lock is activated. 0 sec 0 second
3 sec 3 seconds (Initial condition)
5 sec 5 seconds
ACC power auto cut Time to ACC power cut-off when the electric motor switch is in the ACC position Disable No function
30 min 30 minutes (initial condition)
60 min 60 minutes
Comfort flasher switch time Switch operation time to activate the comfort flasher function Normal 0.4 second (initial condition)
Long 0.8 second
Intelligent washer With/without intelligent washer function Disable No function (Initial condition)
Enable With function
Coming home light Disabling or enabling coming home light function Disable No function
15 sec The headlight illuminate for 15 seconds.
30 sec The headlight illuminate for 30 seconds. (initial condition)
60 sec The headlight illuminate for 60 seconds.
180 sec The headlight illuminate for 180 seconds.
Welcome light Disabling or enabling welcome light function Disable No function
Small light The taillight illuminate. (initial condition)
Head light The headlight illuminate.
Rear wiper (linked reverse gear) Adjustment of automatic rear window wiper operation with reverse gear engaged Enable (R wip.ON) Operates only when the rear wiper switch is ON.
Enable (R/F wip.) Operates only when the front or rear wiper switch is ON. (initial condition)
Sensitivity for theft sensor Sensitivity level setting of theft-alarm sensor <Vehicles with theft-alarm sensor> Level 1 100% sensitivity of theft-alarm sensor (initial condition)
Level 2 90% sensitivity of theft-alarm sensor
Level 3 80% sensitivity of theft-alarm sensor
Level 4 70% sensitivity of theft-alarm sensor
Outer buzzer volume KOS outer buzzer volume adjustment Volume 1 Quieter than the standard
Volume 2 Standard volume (Initial condition)
Volume 3 Louder than the standard
A/C Recirculation Control With/without inside/outside air automatic control function Disable No function
Enable With function (Initial condition)
A/C Switch Control With/without A/C automatic control function Disable No function
Enable With function (Initial condition)
A/C Sensible temp. customize Adjusting mean value for temperature setting -2 Decreases the control temperature two degrees than the temperature displayed on the LCD.
-1 Decreases the control temperature one degree than the temperature displayed on the LCD.
0 No change (Initial condition)
1 Increases the control temperature one degree than the temperature displayed on the LCD.
2 Increases the control temperature two degrees than the temperature displayed on the LCD.
Eco Mode Function to activate ECO mode air-conditioner Eco Activates the ECO mode. (initial condition)
Comfort Deactivates the ECO mode.
FOOT/DEF Air outlet ratio Changes air distribution rate for DEF/FOOT vents during manual operation. Normal D/F2 (Initial condition)
FOOT > DEF D/F1 (more to FOOT vent): More air flows through FOOT vents.
FOOT < DEF D/F3 (more to DEF vent): More air flows through DEF vents.
FACE/FOOT Air outlet ratio Changes air distribution rate for FACE/FOOT vents during manual operation. Normal B/L2 (Initial condition)
FACE > FOOT B/L1 (more to FACE vent): More air flows through FACE vents.
FACE < FOOT B/L3 (more to FOOT vent): More air flows through FOOT vents.
Auto Rear Defogger (Engine Start) Activates the rear window defogger when the ambient temperature is low. (The rear window defogger has never been activated since the electric motor switch was turned on last time) Disable No function (Initial condition)
Enable With function
Charging Lid Light Timer Adjustment of charging port courtesy light illumination time Disable Without function
1 min 1 min
3 min 3 min (initial condition)
5 min 5 min
10 min 10 min
H/L (EV REMOTE Car finder) <Vehicles with MITSUBISHI remote control> Time adjustment of the headlight by using the MITSUBISHI remote control Disable Without function
15 sec 15 sec.
30 sec 30 sec (initial condition)
45 sec 45 sec.
Position (EV REMOTE Car finder) <Vehicles with MITSUBISHI remote control> Time adjustment of the position light by using the MITSUBISHI remote control Disable Without function
15 sec 15 sec.
30 sec 30 sec (initial condition)
45 sec 45 sec.
Gate auto open by Handle SW <Vehicles with power liftgate> Opening operation by using the gate handle switch Disable No function
Enable With function (Initial condition)
NOTE:
(1) F.A.S.T. (Free-hand Advanced Security Transmitter)