Section 40 (Combination Meter)
WARNING: This page is about a different car, the 2020 Mitsubishi Outlander PHEV. However, it is still accessible from the selected car via links, so may be relevant.
- General Information
- Service Specifications
- Special Tools
- Combination Meters Diagnostic
- Diagnostic Trouble Code Chart
- Notes
- Diagnostic Trouble Code Procedures
- DTC B1200: Odometer failure
- DTC B1201: Fuel information problem
- DTC B1209: Test mode
- DTC B2463: Rheostat switch sticking
- DTC B2464: Meter information SW sticking
- DTC U0141: ETACS CAN timeout
- DTC U0159: CAMERA CAN timeout
- DTC U0164: A/C CAN timeout
- DTC U0168: WCM/F.A.S.T. CAN timeout
- DTC U0230: POWER GATE CAN timeout
- DTC U0245: NAVI/DISP.AUDIO CAN timeout
- DTC U1000: OSS CAN timeout
- DTC U1113: EV Remote CAN timeout
- DTC U1190: No receive fault detect signal
- DTC U1195: Coding not completed
- Trouble Symptom Chart
- Notes
- Symptom Procedures
- Inspection Procedure 1: Power supply circuit check; Inspection Procedure 2: The odometer and the trip meter are not displayed. Inspection Procedure 3: No needle meters work.; Inspection Procedure 4: If the electric motor switch is turned to ON, the indicator and warning lights; do not illuminate normally
- Inspection Procedure 5: The speedometer does not work (the other meters work)
- Inspection Procedure 6: Tone alarms do not sound normally
- Inspection Procedure 7: Fuel gauge does not work (the other meters work)
- Inspection Procedure 8: The combination meter light does not illuminate normally or the multi-information display is not displayed normally
- Inspection Procedure 9: The multi-information display screen cannot be changed with the operation of the meter information switch
- Inspection Procedure 10: Parking brake reminder tone alarm does not sound. Inspection Procedure 11: Brake warning lamp does not illuminate
- Inspection Procedure 12: Seat belt reminder function does not work normally
- Inspection Procedure 13: The combination meter and instrument panel illumination does not illuminate normally
- Inspection Procedure 14: The energy usage indicator does not work (the other meters work)
- Inspection Procedure 15: The drive battery level indicator does not work (the other meters work)
- Service Data
- Special Function Table
- Check Procedure For Each Multi Information Display Screen
- Check At Combination Meter Terminals
- On-Vehicle Service
- Fuel Level Sensor Check
- Service Reminder Function Set
- Combination Meter
- Meter Information Switch