Selector Lever Assembly Check

Observe the following chart to check the selector lever assembly. If defective, replace the selector lever assembly.

To measure the voltage, connect the connector to the selector lever assembly. Then turn on the power supply mode of the electric motor switch to measure the voltage at the wiring harness side.

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Terminal number	Item	Selector lever position	Standard value
7 - 8	Shift sensor (main)	Is not operated	2.3 - 2.7 V
		Is held at N position	2.3 - 2.7 V
		Is held at R position	0.59 - 1.49 V
		Is held at D position	3.5 - 4.4 V
		Is held at B position	3.5 - 4.4 V
3 - 4	Shift sensor (sub)	Is not operated	2.3 - 2.7 V
		Is held at N position	2.3 - 2.7 V
		Is held at R position	3.5 - 4.4 V
		Is held at D position	0.59 - 1.49 V
		Is held at B position	0.59 - 1.49 V
5 - 8	Select sensor (main)	Is not operated	2.32 - 2.57 V
		Is held at N position	4.27 - 4.39 V
		Is held at R position
		Is held at D position
		Is held at B position	2.32 - 2.57 V
1 - 4	Select sensor (sub)	Is not operated	2.32 - 2.57 V
		Is held at N position	4.27 - 4.39 V
		Is held at R position
		Is held at D position
		Is held at B position	2.32 - 2.57 V