Work Procedure [After Replacing Chassis Control Module]
- WRITING MAC KEY
With M.U.T.-III SE
Perform MAC key writing. Refer to DESCRIPTION .
>>
GO TO 4.
- PERFORM PROGRAMMING
With M.U.T.-III SE
Perform chassis control module programming according to the procedure of "Programming" in M.U.T.-III SE User's Manual. Refer to M.U.T.-III SE User's Manual.
CAUTION: During programming, maintain the following conditions:- Electric motor switch: ON
- Electric load: OFF
- Brake pedal: Not depressed
- 12V battery voltage: 12 - 13.5 V (Check the value displayed on the M.U.T.-III SE screen.)
>>
GO TO 2.
- PERFORM CONFIGURATION
With M.U.T.-III SE
Perform configuration. Refer to DESCRIPTION .
>>
GO TO 3.
- PERFORM NECESSARY WORK
- Perform Diagnostic Trouble Code for "CHASSIS CONTROL".
- Erase the memory of Diagnostic Trouble Code results.
>>
End of work.