FixVault
Home › Mitsubishi › 2023 › Outlander PHEV ES › Repair and Diagnosis › Body & Frame › Windows › Power Window Control System › DTC/Circuit Diagnosis › Rear Power Window Switch LH › Component Inspection

Component Inspection

  1. CHECK REAR POWER WINDOW SWITCH LH 1 
    1. Turn the power supply mode of the electric motor switch to OFF.
    2. Disconnect rear power window switch LH connector.
    3. Check continuity between rear power window switch LH terminals.
    Terminal Continuity
    1 6 Not existed
    7 Existed
    2 6 Not existed
    7 Existed

    Is the inspection result normal? 

    YES >>

    GO TO  2.

    NO >>

    Replace rear power window switch LH. Refer to REMOVAL AND INSTALLATION .

  2. CHECK REAR POWER WINDOW SWITCH LH 2 

    Check voltage rear power window switch LH terminals under the following conditions.

    Terminal Condition Voltage
    (+) (-)
    1 Ground 12 V direct current supply between terminals 6 (+) and 3 (-). NEUTRAL 0 V
    DOWN 12 V
    2 Ground 12 V direct current supply between terminals 6 (+) and 3 (-). NEUTRAL 0 V
    UP 12 V

    Is the inspection result normal? 

    YES >>

    GO TO  3.

    NO >>

    Replace rear power window switch LH. Refer to REMOVAL AND INSTALLATION .

  3. CHECK REAR POWER WINDOW SWITCH LH 3 
    1. Check voltage rear power window switch LH terminals under the following conditions.
    Terminal Condition Voltage
    (+) (-)
    1 Ground 12 V direct current supply between terminals 6 (+) and 5 (-). 12 V
    No current supply 0 V
    2 Ground 12 V direct current supply between terminals 6 (+) and 4 (-). 12 V
    No current supply 0 V

    Is the inspection result normal? 

    YES >>

    INSPECTION END

    NO >>

    Replace rear power window switch LH. Refer to REMOVAL AND INSTALLATION .

About FixVault