Warning Screen: Acc

WARNING: This page is about a different car, the 2023 Mitsubishi Eclipse Cross. However, it is still accessible from the selected car via links, so may be relevant.

Display content	Message	Factor	Action procedure
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.	-	Displayed when the vehicle-travelling-ahead is decelerating too much, another vehicle interrupts your lane, or your vehicle is too close to the vehicle-travelling-ahead due to poor deceleration on downhill while the ACC is in progress.	If the warning screen is not displayed normally or if the screen continues to be displayed, check the ACC DTC. (Refer to, DIAGNOSTIC TROUBLE CODE CHART .)
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.	ACC RADAR BLOCKED	When the ACC system determines that it cannot detect objects properly, a message will appear on the information screen of the multi-information display.
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.	ACC READY TO RESUME	When the ACC target vehicle is restarted, the distance-keeping controls can be restarted by operating the switch or depressing the accelerator pedal.
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.	ACC SERVICE REQUIRED	Displayed when the ACC system has some abnormality.
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.	APPLY BRAKE	If the ACC system judges that the stationary vehicle hold state can no longer be maintained on a steep slope after your vehicle stops when the vehicle in front stops, the stationary vehicle hold state is cancelled and a warning appears on the information screen of the multi-information display.
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.	APPLY BRAKE	It may be displayed when there is an abnormality in the auto hold function. For details, refer to the item of ASC.
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.	ACC CANCELLED	Displayed when ACC stops due to one of the following conditions. When the ASC is turned off. When ABS, ASC or TCL is in operation. When the parking brake is applied. When the selector lever is in the "P", "R" or the "N" position. When the driver's seat belt is unfastened. When the driver's door is opened. When the ACC no longer detects any vehicle in front while it is in the stationary vehicle hold state. When the vehicle is stationary for 10 minutes or more. When the system detects the vehicle sliding down a slope.	If the warning screen is not displayed normally or if the screen continues to be displayed, check the ACC DTC. (Refer to, DIAGNOSTIC TROUBLE CODE CHART .)
	ACC NOT AVAILABLE NOW	Conditions for the start of control are not met, the ACC cannot start the control.
	ACC OUT OF SPEED RANGE	The ACC cannot start the control because the speed is out of speed range.
	ACC NO FORWARD VEHICLE	The ACC cannot start the control because not detected the approach of the vehicles in front.
	ACC TEMPORARILY NOT AVAILABLE	The ACC is not available temporarily such as for adhesion of contaminants to the sensor. This is not a malfunction.