Work Procedure

WARNING: This page is about a different car, the 2023 Mitsubishi Outlander PHEV. However, it is still accessible from the selected car via links, so may be relevant.

Always perform the distance sensor configuration after replacing the distance sensor.
Always perform the radar alignment after removing and installing or replacing the distance sensor.

CAUTION: The system does not operate normally unless the distance sensor configuration and the radar alignment are performed. Always perform them.

Perform the FCM system action test to check that the FCM system operates normally.

DISTANCE SENSOR CONFIGURATION
Perform the distance sensor configuration with M.U.T.-III SE. Refer to WORK PROCEDURE .

>>

GO TO 2.
PERFORM RADAR ALIGNMENT
Perform the radar alignment. Refer to WORK PROCEDURE .

>>

GO TO 3.
FCM SYSTEM ACTION TEST
1. Perform the following system action test.
  - LDW: Refer to Work Procedure INSPECTION PROCEDURE .
  - LDP: Refer to Work Procedure INSPECTION PROCEDURE .
  - BSW: Refer to WORK PROCEDURE .
  - Active Blind Spot Assist [ABSA]: Refer to WORK PROCEDURE .
  - TSR: Refer to WORK PROCEDURE .
  - RCTA: Refer to WORK PROCEDURE .
  - DAA: Refer to WORK PROCEDURE .
2. Check that the each system operates normally.
>>

INSPECTION END