Work Procedure [After Replacing Chassis Control Module]
- Writing Mac Key
With M.U.T.-Iii Se
Perform Mac Key Writing. Refer To description .
Go To 2.
- Perform Programming
With M.U.T.-Iii Se
Perform Chassis Control Module Programming According To The Procedure Of "Programming" In M.U.T.-Iii Se User's Manual. Refer To M.U.T.-Iii Se User's Manual.
CAUTION: During Programming, Maintain The Following Conditions:- Electric Motor Switch: On
- Electric Load: Off
- Brake Pedal: Not Depressed
- 12V Battery Voltage: 12 - 13.5 V (Check The Value Displayed On The M.U.T.-Iii Se Screen.)
Go To 3.
- Perform Configuration
With M.U.T.-Iii Se
Perform Configuration. Refer To description .
Go To 4.
- Perform Necessary Work
- Perform Diagnostic Trouble Code For "Chassis Control".
- Erase The Memory Of Diagnostic Trouble Code Results.
End Of Work.