Line Pressure Test Procedure

1. Warm engine and transaxle to normal operating temperature. Check engine and transaxle fluid levels and add fluid as necessary. Install pressure gauge to line pressure port. See Fig 1.
2. Set parking brake and block wheels. Apply foot brake fully while line pressure test at stall speed is performed. Start engine and measure line pressure at idle and stall speed in "D", "2", "1" and "R" positions. When measuring line pressure at stall speed, follow the stall speed test procedure. Note pressure readings and refer to the

LINE PRESSURE SPECIFICATIONS  table.

Fig 1: Identifying Hydraulic Pressure Test Port

Courtesy of NISSAN MOTOR CO., U.S.A.