FixVault
Home › Nissan-Datsun › 2002 › Altima Base, 3.5 B › Repair and Diagnosis › Body & Frame › Door Locks › Remote Keyless Entry System › Programming › Id Code Entry Procedure › Key Fob ID Set Up With Consult-II

Key Fob ID Set Up With Consult-II

NOTE: If a key fob is lost, the ID code of the lost key fob must be erased to prevent unauthorized use. When the ID code of a lost key fob is not known, all controller ID codes should be erased. After all ID codes are erased, the ID codes of all remaining and/or new key fobs must be re-registered.
  1. Turn ignition switch "OFF".
  2. Connect "CONSULT-II" to the data link connector.
  3. Turn ignition switch "ON".
  4. Touch "START".
  5. Touch "BCM".
  6. Touch "MULTI REMOTE ENT".
  7. Touch "WORK SUPPORT".
  8. The following items can be set up:

    • "REMO CONT ID CONFIR"

      Use this mode to confirm if a key fob ID code is registered or not.
      • NOTE: Register the ID code when key fob or BCM is replaced, or when additional key fob is required.

    • "REMO CONT ID REGIST"
      Use this mode to register a key fob ID code.

    • "REMO CONT ID ERASUR"

      Use this mode to erase a key fob ID code.
About FixVault