Id Code Entry Procedure: Notes

NOTE: If a key fob is lost, the ID code of the lost key fob must be erased to prevent unauthorized use. A specific ID code can be erased with CONSULT-II. However, when the ID code of a lost key fob is not known, all controller ID codes should be erased. After all ID codes are erased, the ID codes of all remaining and/or new key fobs must be re-registered.

NOTE: To erase all ID codes in memory, register one ID code (key fob) 5 times. After all ID codes are erased, the ID codes of all remaining and/or new key fobs must be re-registered.

NOTE: When registering an additional key fob, the existing ID codes in memory may or may not be erased. If 4 ID codes are stored in memory, when an additional code is registered, only the oldest code is erased. If less than 5 ID codes are stored in memory, when an additional ID code is registered, the new ID code is added and no ID codes are erased.

NOTE: If you need to activate more than 2 additional new key fobs, repeat the procedure "Additional ID code entry" for each new key fob. See KEY FOB ID SET UP WITHOUT CONSULT-II .

NOTE: Entry of maximum 5 ID codes is allowed. When more than 4 ID codes are entered, the oldest ID code will be erased.

NOTE: Even if same ID code that is already in the memory is input, the same ID code can be entered. The code is counted as an additional code.