Trouble Diagnoses with Battery/Starting/Charging System Tester: Notes

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: To ensure a complete and thorough diagnosis, the battery, starter and generator test segments must be done as a set from start to finish.

Turn off all loads on the vehicle electrical system.
Perform battery test with Battery/Starting/Charging system tester. Refer to "TROUBLE DIAGNOSES WITH BATTERY/STARTING/CHARGING SYSTEM TESTER ".
Press "ENTER" to begin the starting system test.

Fig 1: Starter Tester Diagnosis Function Display (1 Of 3)
Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 2: Starter Tester Diagnosis Function Display (2 Of 3)
Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 3: Starter Tester Diagnosis Function Display (3 Of 3)
Courtesy of NISSAN MOTOR CO., U.S.A.
Start the engine.
Diagnosis result is displayed on the tester. Refer to "DIAGNOSTIC RESULT ITEM CHART ".
NOTE:
- If the starter performs normally but the engine does not start, perform engine diagnosis.
- For intermittent "NO CRANK" or "NO STARTER OPERATION" incidents, refer to "DIAGNOSTIC PROCEDURE 2 ".