FixVault
Home › Nissan-Datsun › 2002 › Sentra SE-R, Automatic › Repair and Diagnosis › External Pages › Different car › Section 1575 (Front Axle) › Drive Shaft › Disassembly and Assembly › Assembly › Wheel Side

Wheel Side

WARNING: This page is about a different car, the 2005 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Insert the Genuine NISSAN Grease or equivalent, into the joint sub-assembly serration hole until the grease begins to ooze from the ball groove and serration hole. Refer to RECOMMENDED FLUIDS AND LUBRICANTS . After inserting the grease, use a shop cloth to wipe off the grease that has oozed out.
    Fig 1: Inserting Grease Into Joint Sub-Assembly Serration Hole
    G03603234Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Wrap the serrated part of the drive shaft with tape. Install the boot band and boot onto the shaft. Do not damage the boot.
    Fig 2: Installing Boot Band & Boot Onto Shaft
    G03603235Courtesy of NISSAN MOTOR CO., U.S.A.
    NOTE: Discard the old boot band and boot and use a new one for assembly.
  3. Remove the protective tape wound around the serrated part of the drive shaft.
  4. Attach the circlip to the drive shaft. The circlip must fit securely into the drive shaft groove. Attach the nut to the joint sub-assembly.

    Use a soft hammer to press-fit the circlip.

    Fig 3: Installing Circlip With Soft Hammer
    G03603236Courtesy of NISSAN MOTOR CO., U.S.A.
    NOTE: Discard the old circlip and use a new one for assembly.
  5. Insert the specified quantity of Genuine NISSAN Grease or equivalent, into the joint sub-assembly and the large end of the boot. Refer to RECOMMENDED FLUIDS AND LUBRICANTS .

    Grease capacity: 145 - 165 g (5.11 - 5.82 oz) 

  6. Install the boot securely into the grooves (indicated by the * marks) as shown.
    CAUTION: If there is grease on the boot mounting surfaces (indicated by the * marks) of the drive shaft and joint sub-assembly, the boot may come off. Remove all grease from the drive shaft surfaces.
    7. Fig 4: Installing Boot Securely Into Grooves
    G03603237Courtesy of NISSAN MOTOR CO., U.S.A.
  7. Check that the boot installation length "L" is the specified length. Insert a flat-tip screwdriver or similar tool into the smaller side of the boot. Bleed the air from the boot to prevent boot deformation.

    Boot installation length "L": 168.4 mm (6.63 in) 

    CAUTION:
    • The boot may break if the boot installation length is less than the specified length.
    • Do not contact inside surface of boot with the tip of the screwdriver.
  8. Secure the big and small ends of the boot using new boot bands as shown.
    NOTE: Discard the old boot bands and use new ones for assembly.
    Fig 5: Securing Big And Small Ends Of Boot Using Boot Bands
    G03603238Courtesy of NISSAN MOTOR CO., U.S.A.
  9. After installing the joint sub-assembly to the drive shaft, rotate the boot to check that it is positioned correctly. If the boot is not positioned correctly, reposition the boot and secure the boot using a new boot band.
About FixVault