Liquid Gasket Application Procedure

WARNING: This page is about a different car, the 2002 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

Use a scraper to remove all traces of old liquid gasket from mating surfaces and grooves. Also, completely clean any oil from these areas.
Apply a continuous bead of liquid gasket to mating surfaces. (Use Genuine RTV silicone sealant or equivalent. )
- Be sure liquid gasket diameter is as specified.
  
  Fig 1: Locating Bolt Hole And Groove
  Courtesy of NISSAN MOTOR CO., U.S.A.
Apply liquid gasket around the inner side of bolt holes (unless otherwise specified).
Assembly should be done within 5 minutes after coating.
Wait at least 30 minutes before refilling engine oil and engine coolant.

Fig 2: Locating Groove
Courtesy of NISSAN MOTOR CO., U.S.A.