Precautions for Brake System

WARNING: This page is about a different car, the 2005 Infiniti G35. However, it is still accessible from the selected car via links, so may be relevant.

Recommended fluid is brake fluid "DOT 3".
Never reuse drained brake fluid.
Be careful not to splash brake fluid on painted areas.
To clean or wash all parts of master cylinder, disc brake caliper and wheel cylinder, use clean brake fluid.
Never use mineral oils such as gasoline or kerosene. They will ruin rubber parts of the hydraulic system.
Use a flare nut wrench when removing a brake tube and use a flare nut torque wrench when installing a brake tube.

Fig 1: Using Flare Nut Wrench When Removing A Brake Tube
Courtesy of NISSAN MOTOR CO., U.S.A.
When installing brake piping, be sure to check torque.
Before working, turn ignition switch OFF and disconnect connectors of VDC/TCS/ABS control unit or the battery cable from the negative terminal.
Burnish the brake contact surfaces after refinishing or replacing drums or rotors, after replacing pads or linings, or if a soft pedal occurs at very low mileage.
Refer to "BRAKE BURNISHING PROCEDURE ".

WARNING:

Collect dust on brake parts with dust collector. Do not blow off the dust.