Removal and Installation: Removal

WARNING: This page is about a different car, the 2008 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

Remove the glove box assembly. Refer to "GLOVE BOX ".
Remove the screws (A) and the center lower trim (1).

Fig 1: Identifying Screws And Center Lower Trim
Courtesy of NISSAN MOTOR CO., U.S.A.
Remove the center stack lower trim RH.

Fig 2: Identifying Center Stack Lower Trim RH And LH
Courtesy of NISSAN MOTOR CO., U.S.A.
Disconnect the intake sensor electrical connector.
Twist the intake sensor to remove the intake sensor from the front heater and cooling unit assembly.