FixVault
Home › Nissan-Datsun › 2002 › Sentra SE-R, Automatic › Repair and Diagnosis › External Pages › Different car › Section 2128 (Body, Lock & Security System) › Automatic Sliding Door System › Magnetic Clutch Line Check

Magnetic Clutch Line Check

WARNING: This page is about a different car, the 2008 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. MAGNETIC CLUTCH SIGNAL INSPECTION 
    1. Turn ignition switch OFF.
    2. Operate the sliding door and check voltage waveform between sliding door control unit connector B69 (LH) or B141 (RH) terminal 34 and ground using an oscilloscope.
      TERMINALS VOLTAGE CHART

      34 - Ground
      G04907155Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    OK: GO TO 2.

    NG: Replace sliding door control unit.

    Fig 1: Checking Voltage Waveform Between Sliding Door Control Unit Connector B69 Or B141 Terminal 34 And Ground
    G04907174Courtesy of NISSAN MOTOR CO., U.S.A.
  2. MAGNETIC CLUTCH GROUND CIRCUIT INSPECTION 

    Check continuity between sliding door control unit connector B69 (LH) or B141 (RH) terminal 37 and ground.

    37 - Ground : Continuity should exist. 

    OK or NG 

    OK: Clutch circuit is OK.

    NG: Repair or replace harness.

    Fig 2: Checking Continuity Between Sliding Door Control Unit Connector B69 Or B141 Terminal 37 And Ground
    G04907175Courtesy of NISSAN MOTOR CO., U.S.A.
About FixVault