FixVault
Home › Nissan-Datsun › 2002 › Sentra SE-R, Automatic › Repair and Diagnosis › External Pages › Different car › Section 394 (Engine Control System) › DTC P0500: VSS › DTC Confirmation Procedure › With CONSULT-II

With CONSULT-II

WARNING: This page is about a different car, the 2004 Infiniti M45. However, it is still accessible from the selected car via links, so may be relevant.
  1. Start engine (VDC switch OFF).
  2. Read "VHCL SPEED SE" in "DATA MONITOR" mode with CONSULT-II. The vehicle speed on CONSULT-II should exceed 10 km/h (6 MPH) when rotating wheels with suitable gear position.
    Fig 1: Scan Tool Display - Data Monitor
    G00796150Courtesy of NISSAN MOTOR CO., U.S.A.

    If NG, go to DIAGNOSTIC PROCEDURE .

    If OK, go to following step.

  3. Select "DATA MONITOR" mode with CONSULT-II.
  4. Warm engine up to normal operating temperature.
  5. Maintain the following conditions for at least 60 consecutive seconds.
    Fig 2: Inspecting Conditions Chart
    G00796151Courtesy of NISSAN MOTOR CO., U.S.A.
  6. If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE .
About FixVault