FixVault
Home › Nissan-Datsun › 2002 › Sentra SE-R, Standard › Repair and Diagnosis › External Pages › Different car › Section 1094 (Brake Control System) › Abs › Trouble Diagnosis › CONSULT-II Functions › Self-Diagnosis › Operation Procedure

Operation Procedure

WARNING: This page is about a different car, the 2004 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch OFF.
  2. Connect CONSULT-II and CONSULT-II CONVERTER to data link connector.
    CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which performs CAN communication.
  3. Turn ignition switch ON.
  4. Start engine and drive at approximately 30 km/h (19 MPH) for approximately 1 minute.
  5. After stopping vehicle, with engine running at idle speed, touch "START (NISSAN BASED VHCL)", "ABS", "SELF-DIAG RESULTS" in order on CONSULT-II screen.
  6. If "ABS" is not indicated, go to " CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT  ". 
    CAUTION:
    • If there is no error during CONSULT-II use, ABS warning lamp may be turned ON/OFF.
    • If "START (NISSAN BASED VHCL)" is touched immediately after starting engine or turning on ignition switch, "ABS" might not be displayed in System Selection screen. In this case, repeat operation from step 1. If it connect be shown after several attempts, ABS actuator and electric unit (control unit) may have malfunction. Repair or replace control unit.
  7. The self-diagnostic results are displayed. (If necessary, self-diagnostic results can be printed out by touching "PRINT".)
    • When "NO FAILURE" is displayed, check ABS warning lamp.
  8. Conduct appropriate inspection from the display item list, and repair or replace malfunctioning component.
  9. Start engine and drive at approximately 30 km/h (19 MPH) for approximately 1 minute.
    CAUTION:
    • When a wheel sensor "short-circuit" is detected, if vehicle is not driven at 30 km/h for at least 1 minute, ABS warning lamp will not turn off even if everything is normal.
    • Check again to make sure that there is no malfunction on other parts.
  10. Turn ignition switch OFF to prepare for erasing the memory.
  11. Start engine and touch "START (NISSAN BASED VHCL)", "ABS", "SELF-DIAG RESULTS", "ERASE MEMORY" in order on CONSULT-II screen to erase the error memory.
    CAUTION: If the error memory is not erased, re-conduct the operation from step 5 again.
  12. For final inspection, drive at approximately 30 km/h (19 MPH) for approximately 1 minute and confirm that ABS warning lamp turn OFF.
About FixVault