Removal and Installation: Installation

WARNING: This page is about a different car, the 2005 Nissan 350Z. However, it is still accessible from the selected car via links, so may be relevant.

Note the following, and install in the reverse order of removal.

Do not allow engine mounting insulator to be damage and careful no engine oil gets on it.
For a location with a positioning pin, insert it securely into hole of mating part.
For a part with a specified installation orientation, refer to component figure in "REMOVAL AND INSTALLATION ".
When installing engine mounting brackets (RH and LH) on cylinder block, tighten two upper bolts (shown as "A" in the figure) first. Then tighten two lower bolts (shown as "B" in the figure).

Fig 1: Installing Engine Mounting Brackets
Courtesy of NISSAN MOTOR CO., U.S.A.
Make sure all engine mounting insulators are seated properly, then tighten mounting nuts.
Tighten rear engine mounting member bolts in numerical order as shown in the figure.

Fig 2: Tightening Rear Engine Mounting Member Bolts (M/T models)
Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 3: Tightening Rear Engine Mounting Member Bolts (A/T models)
Courtesy of NISSAN MOTOR CO., U.S.A.