All Warnings Are Not Operated

WARNING: This page is about a different car, the 2005 Nissan 350Z. However, it is still accessible from the selected car via links, so may be relevant.

CHECK CHIME OPERATION
1. Select "BCM" on CONSULT-II.
2. Select "BUZZER" on CONSULT-II, and then perform "KEY WARN ALM", "LIGHT WARN ALM" or "SEAT BELT ALM" of "ACTIVE TEST".
Does chime sound?
- YES : Check battery power supply circuit of unified meter and A/C amp. If OK, replace BCM. Refer to "REMOVAL AND INSTALLATION OF BCM ".
- NO : GO TO 2.
Fig 1: Scan Tool Display "Active Test"
Courtesy of NISSAN MOTOR CO., U.S.A.
CHECK UNIFIED METER AND A/C AMP. INPUT SIGNAL
1. Select "METER A/C AMP" on CONSULT-II.
2. Operate switches meet the requirements to sounds warning chime with "BUZZER" of "DATA MONITOR" and check operation status.
  - "BUZZER"
  - When meet the requirements to : ON
  - sounds warning chime
  - Except above : OFF
  Fig 2: Scan Tool Display "Data Monitor"
  Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
- OK : Check battery power supply circuit of combination meter. If OK, replace combination meter.
- NG : Replace BCM. Refer to "REMOVAL AND INSTALLATION OF BCM ".