Door Mirror Remote Control Switch (Changeover Switch) Circuit Check

With CONSULT-II 

Check the operation on "MIR CHNG SW-R" or "MIR CHNG SW-L" in the DATA MONITOR.

Fig 1: CONSULT-II Screen Display - MIR CHNG SW-R Or MIR CHNG SW-L In DATA MONITOR

Courtesy of NISSAN MOTOR CO., U.S.A.

Without CONSULT-II 

1. Turn ignition switch to ACC.
2. Check voltage between automatic drive positioner control unit connector and ground.
   TERMINALS VOLTAGE REFERENCE
   
   

   Connector	Terminals		Condition	Voltage (V) (Approx.)
   	(+)	(-)
   M41	2	Ground	Changeover switch RIGHT position	0
   			Other than above	5
   	18		Changeover switch LEFT position	0
   			Other than above	5

   Fig 2: Identifying Voltage Between Automatic Drive Positioner Control Unit Connector And Ground

   Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: Door mirror remote control switch (changeover switch) is OK.

NG: GO TO 2.

1. Turn ignition switch OFF.
2. Disconnect automatic drive positioner control unit and door mirror remote control switch.
3. Check continuity between automatic drive positioner control unit connector (A) M41 terminals 2, 18 and door mirror remote control switch connector (B) M7 terminals 5, 6.

   2 - 5: Continuity should exist. 

   18 - 6: Continuity should exist. 

4. Check continuity between automatic drive positioner control unit connector (A) M41 terminals 2, 18 and ground.

   2 - Ground: Continuity should not exist. 

   18 - Ground: Continuity should not exist. 

   Fig 3: Identifying Continuity Between Connector (A) M41 Terminals 2, 18 And Connector (B) M7 Terminals 5, 6

   Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: GO TO 3.

NG: Repair or replace harness.

Check continuity between door mirror remote control switch terminals as follows.

Fig 4: Identifying Continuity Between Door Mirror Remote Control Switch Terminals

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

OK: Check the condition of the harness and the connector.

NG: Replace door mirror remote control switch.