Front Power Window Motor RH Circuit Check

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

CHECK POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH RH OUTPUT SIGNAL

Turn ignition switch ON.

Check voltage between power window and door lock/unlock switch RH connector D105 terminals 8, 9 and ground.

VOLTAGE SPECIFICATION CHART

Connector	Terminals		Condition	Voltage (V) (Approx.)
Connector	(+)	(-)	Condition	Voltage (V) (Approx.)
D105	9	Ground	UP	0
	9		DOWN	Battery voltage
	8		UP	Battery voltage
	8		DOWN	0

Fig 1: Checking Voltage Between Door Lock/Unlock Switch RH Connector Terminals 8 9 And Ground

OK or NG

OK: GO TO 2.

NG: Replace power window and door lock/unlock switch RH. Refer to "REMOVAL AND INSTALLATION ".

CHECK FRONT POWER WINDOW MOTOR RH CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect front power window motor RH and power window and door lock/unlock switch RH.
3. Check continuity between power window and door lock/unlock switch RH connector D105 (A) terminals 8, 9 and front power window motor RH connector D104 (B) terminals 1, 2.
  8 - 2 : Continuity should exist.
  
  9 - 1 : Continuity should exist.
  
  Fig 2: Checking Continuity Between Power Window And Door Lock/Unlock Switch RH Connector D105 (A) Terminals 8, 9
OK or NG

OK: Replace front power window motor RH. Refer to "FRONT DOOR GLASS REGULATOR ".

NG: Repair or replace harness.