FixVault
Home › Nissan-Datsun › 2002 › Sentra SE-R, Standard › Repair and Diagnosis › External Pages › Different car › Section 2012 (Glass, Window & Mirrors) › Power Window System › Limit Switch Circuit Check Front RH

Limit Switch Circuit Check Front RH

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH RH LIMIT SIGNAL 
    1. Turn ignition switch ON.
    2. Check voltage between power window motor RH connector D105 terminal 15 and ground.
      VOLTAGE SPECIFICATION CHART

      Connector Terminals Condition Voltage (V) (Approx.)
      (+) (-)
      D105 15 Ground Front power window RH is between fully-open and just before fully-closed position (ON) 0
      Front power window RH is between just before fully-closed position and fully-closed position (OFF) 5
      Fig 1: Checking Voltage Between Door Lock/Unlock Switch Terminal 15 And Ground
      G04902754

    OK or NG 

    OK: Limit switch circuit is OK.

    NG: GO TO 2.

  2. CHECK FRONT POWER WINDOW MOTOR RH LIMIT SIGNAL 
    1. Turn ignition switch OFF.
    2. Disconnect front power window motor RH.
    3. Turn ignition switch ON.
    4. Check voltage between front power window motor RH connector D104 terminal 5 and ground.

      5 - Ground : Approx. 5V 

      Fig 2: Checking Voltage Between Front Power Window Motor RH Connector D104 Terminal 5 And Ground
      G04912946

    OK or NG 

    OK: GO TO 3.

    NG: GO TO  5.

  3. CHECK LIMIT SWITCH GROUND CIRCUIT 
    1. Turn ignition switch OFF.
    2. Check continuity between front power window motor RH connector D104 terminal 4 and ground.

      4 - Ground : Continuity should exist. 

      Fig 3: Checking Continuity Between Front Power Window Motor RH Connector D104 Terminal 4 And Ground
      G04912939

    OK or NG 

    OK: Replace front power window motor RH. Refer to "FRONT DOOR GLASS REGULATOR ".

    NG: GO TO 4.

  4. CHECK HARNESS CONTINUITY 
    1. Disconnect power window and door lock/unlock switch RH.
    2. Check continuity between front power window motor RH connector D104 (A) terminal 4 and power window and door lock/ unlock switch RH connector D105 (B) terminal 3.

      4 - 3 : Continuity should exist. 

      Fig 4: Checking Continuity Between Front Power Window Motor RH Connector D104 Terminal 4 And D105 Terminal 3
      G04912948

    OK or NG 

    OK: Replace power window and door lock/unlock switch RH. Refer to "FRONT DOOR ".

    NG: Repair or replace harness.

  5. CHECK HARNESS CONTINUITY 
    1. Turn ignition switch OFF.
    2. Disconnect power window and door lock/unlock switch RH.
    3. Check continuity between power window and door lock/unlock switch RH connector D105 (A) terminal 15 and front power window motor RH connector D104 (B) terminal 5.

      15 - 5 : Continuity should exist. 

      Fig 5: Checking Continuity Between Power Window And Door Lock/Unlock Switch Rh Connector D105 (A) Terminal 15
      G04912949

    OK or NG 

    OK: Replace power window and door lock/unlock switch RH. Refer to "FRONT DOOR ".

    NG: Repair or replace harness.

About FixVault