Component Inspection

WARNING: This page is about a different car, the 2004 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition switch "OFF".
Disconnect 4LO switch harness connector.
Remove 4LO switch.
Push and release 4LO switch and check continuity between 4LO switch harness connector F60 terminals 12 and 13.

Fig 1: Continuity Chart
Courtesy of NISSAN MOTOR CO., U.S.A.
If NG, replace the 4LO switch.

Fig 2: Checking Continuity

Courtesy of NISSAN MOTOR CO., U.S.A.