Overall Function Check
WARNING: This page is about a different car, the 2004 Nissan Frontier. However, it is still accessible from the selected car via links, so may be relevant.
Use this procedure to check the overall function of the closed loop control. During this check, a DTC might not be confirmed.
WITH GST
- Start engine and warm it up to normal operating temperature.
- Set voltmeter probes between ECM terminal 50 [HO2S1 (B1) signal] or 51 [HO2S1 (B2) signal] and engine ground.
- Check the following with engine speed held at 2, 000 RPM constant under no-load.
- The voltage should go above 0.70V at least once.
- The voltage should go below 0.21V at least once.
- If NG, go to "DIAGNOSTIC PROCEDURE ".