FixVault
Home › Nissan-Datsun › 2003 › Sentra SE-R, Automatic › Repair and Diagnosis › External Pages › Different car › Section 1112 (Brake Control System) › VCD/TCS/Abs › Trouble Diagnosis › CONSULT-II Functions › Self-Diagnosis › Operation Procedure

Operation Procedure

WARNING: This page is about a different car, the 2004 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch OFF.
  2. Connect CONSULT-II and CONSULT-II CONVERTER to the data link connector.
    CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which performs CAN communication.
  3. Turn ignition switch ON.
  4. Start engine and drive at approximately 30 km/h (19 MPH) or more for approximately 1 minute.
  5. After stopping the vehicle, with engine running at idle speed, touch "START (NISSAN BASED VHCL)", "ABS", "SELF-DIAG RESULTS" in order on the CONSULT-II screen.

    If "ABS" is not indicated, go to "CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT ".

    CAUTION:
    • If there is no error during CONSULT-II use, ABS warning lamp, VDC OFF indicator lamp, SLIP indicator lamp may be turned ON/OFF.
    • If "START (NISSAN BASED VHCL)" is touched immediately after starting engine or turning on ignition switch, "ABS" might not be displayed in the System Selection screen. In this case, repeat the operation from step 1. If it connect be shown after several attempts, ABS actuator and electric unit (control unit) may have malfunction. Repair or replace control unit.
  6. The self-diagnostic results are displayed. (If necessary, the self-diagnostic results can be printed out by touching "PRINT".)
    • When "NO FAILURE" is displayed, check ABS warning lamp, VDC OFF indicator lamp, and SLIP indicator lamp.
  7. Conduct the appropriate inspection from the display item list, and repair or replace the malfunctioning component.
  8. Start engine and drive at approximately 30 km/h (19 MPH) or more for approximately 1 minute.
    CAUTION:
    • When a wheel sensor "short-circuit" is detected, if the vehicle is not driven at 30 km/h (19 MPH) for at least 1 minute, ABS warning lamp will not turn off even if everything is normal.
    • Check again to make sure that there is no malfunction on other parts.
  9. Turn ignition switch OFF to prepare for erasing the memory.
  10. Start engine and touch "START (NISSAN BASED VHCL)," "SELF-DIAG RESULTS", "ERASE MEMORY" in order on the CONSULT-II screen to erase the error memory.
    CAUTION: If the error memory is not erased, re-conduct the operation from step 5.
  11. For the final inspection, drive at approximately 30 km/h (19 MPH) or more for approximately 1 minute and confirm that ABS warning lamp, VDC OFF indicator lamp, and SLIP indicator lamp are OFF.
    CAUTION: VDC "OFF" switch should not stay in the "ON" position.
About FixVault