With Consult-II

WARNING: This page is about a different car, the 2005 Infiniti FX35. However, it is still accessible from the selected car via links, so may be relevant.

Wait until engine coolant temperature is less than 90°C (194°F)
1. Turn ignition switch ON.
2. Select "DATA MONITOR" mode with CONSULT-II.
3. Check the engine coolant temperature.
4. If the engine coolant temperature is not less than 90°C (194°F), turn ignition switch OFF and cool down engine.
  - Perform the following steps before engine coolant temperature is above 90°C (194°F).
Fig 1: Identifying Scan Tool Display - Data Monitor
Courtesy of NISSAN MOTOR CO., U.S.A.
Turn ignition switch ON.
Select "DATA MONITOR" mode with CONSULT-II.
Start engine.
Hold vehicle speed at more than 70 km/h (43 MPH) for 100 consecutive seconds.
If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".