Removal and Installation: Installation

WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in the reverse order of removal.

Refer to "POWER STEERING GEAR AND LINKAGE " and "POWER STEERING OIL PUMP " for tightening torque.
NOTE: Do not reuse non-reusable parts.
Ensure that hose touches spool of tube when tube is to be inserted to hose.
CAUTION: Do not apply power steering fluid to the junction surface between tube and hose.

Fig 1: Identifying Hose & Spool
Courtesy of NISSAN MOTOR CO., U.S.A.
To install the eye joint on the power steering pump, align the projection of the eye joint into the notch of the power steering pump. Make sure the eye joint is properly installed on the power steering pump, then tighten the eye bolt to the specified torque.
Connect the harness connector into the power steering pressure sensor securely.

Fig 2: Pressure Sensor - With Torque Specifications
Courtesy of NISSAN MOTOR CO., U.S.A.