FixVault
Home › Nissan-Datsun › 2003 › Sentra SE-R, Automatic › Repair and Diagnosis › External Pages › Different variant/trim › Section 5 (Automatic Transaxle (Re4F03B)) › Manual Shaft › Removal

Manual Shaft: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove detent spring from transmission case.
    Fig 1: Removing Detent Spring From Transmission Case
    G01319561Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Drive out manual plate retaining pin using Tool.
    Fig 2: Driving Out Manual Plate Retaining Pin
    G01319562Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Drive and pull out parking rod plate retaining pin using Tool.
    4. Fig 3: Driving And Pulling Out Parking Rod Plate Retaining Pin
    G01319563Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Remove parking rod plate from manual shaft.
  5. Draw out parking rod from transmission case.
  6. Pull out manual shaft retaining pin.
    Fig 4: Pulling Out Manual Shaft Retaining Pin
    G01319564Courtesy of NISSAN MOTOR CO., U.S.A.
  7. Remove manual shaft and manual plate from transmission case.
  8. Remove manual shaft oil seal.
    Fig 5: Removing Manual Shaft Oil Seal
    G01319565Courtesy of NISSAN MOTOR CO., U.S.A.
About FixVault