FixVault
Home › Nissan-Datsun › 2003 › Sentra SE-R, Standard › Repair and Diagnosis › External Pages › Different car › Section 2006 (Seats) › Automatic Drive Positioner › CONSULT-II Function (AUTO DRIVE POS.) › Consult-II Inspection Procedure

Consult-II Inspection Procedure

WARNING: This page is about a different car, the 2006 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carries out CAN communication.
  1. Turn ignition switch OFF.
  2. Connect CONSULT-II and CONSULT-II CONVERTER to the data link connector.
  3. Turn ignition switch ON.
    Fig 1: Connecting CONSULT-II To Data Link Connector
    G04756487
  4. Touch "START (NISSAN BASED VHCL)".
    Fig 2: CONSULT-II Display - START (NISSAN BASED VHCL)
    G04756488
  5. Touch "AUTO DRIVE POS".

    If "AUTO DRIVE POS." is not indicated, refer to CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT .

    Fig 3: CONSULT-II Display - AUTO DRIVE POS
    G04756489
  6. Select diagnosis mode.

    "DATA MONITOR""ACTIVE TEST""SELF-DIAG RESULTS""ECU PART NUMBER" and "WORK SUPPORT" are available.

    Fig 4: CONSULT-II Display - WORK SUPPORT
    G04756490
About FixVault