Power Window Regulator (Front Passenger Side) Circuit Check

WARNING: This page is about a different car, the 2003 Infiniti G35. However, it is still accessible from the selected car via links, so may be relevant.

CHECK POWER WINDOW SUB-SWITCH (FRONT PASSENGER SIDE) OUTPUT SIGNAL
1. Connect power window sub-switch (front passenger side) connector.
2. Turn ignition switch ON.
3. Check voltage between power window sub-switch (front passenger side) connector D37 terminal 4 and 5.
Fig 1: Power Window Sub-Switch Output Signal Reference Data Table
Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 2: Checking Voltage Between Power Window Sub-Switch And Ground
Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG
1. OK : GO TO 2.
2. NG : Replace power window sub-switch (front passenger side).
CHECK POWER WINDOW REGULATOR (FRONT PASSENGER SIDE) CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect power window regulator (front passenger side) and power window sub-switch (front passenger side) connector.
3. Check continuity between power window sub-switch (front passenger side) connector D37 terminals 4, 5 and power window regulator (front passenger side) connector D38 terminals 1, 2.
  1. 4 (G) - 1 (G): Continuity should exist.
  2. 5 (L) - 2 (L): Continuity should exist.
OK or NG
1. OK : Replace power window regulator (front passenger side)
2. NG : Repair or replace harness between power window sub-switch (front passenger side) and power window regulator (front passenger side).
Fig 3: Checking Continuity Between Power Window Sub-Switch And Power Window Regulator
Courtesy of NISSAN MOTOR CO., U.S.A.