Active Test Procedure

WARNING: This page is about a different car, the 2002 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.

When conducting Active test, vehicle must be stationary.
When ABS warning lamp stays on, never conduct Active test.

Turn ignition switch OFF.
Connect CONSULT-II to data link connector.
Start engine.
Touch "START" on CONSULT-II screen.

Fig 1: CONSULT-II Display - Touch "START"
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "ABS".

Fig 2: CONSULT-II Display - Touch "ABS"
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "ACTIVE TEST".

Fig 3: CONSULT-II Display - Touch "ACTIVE TEST"
Courtesy of NISSAN MOTOR CO., U.S.A.
Select active test item by touching screen.

Fig 4: CONSULT-II Display - Select DIAG Mode
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "START".
Carry out the active test by touching screen key.

Fig 5: CONSULT-II Display - Select Monitor Item Mode
Courtesy of NISSAN MOTOR CO., U.S.A.