FixVault
Home › Nissan-Datsun › 2004 › Altima SE, Automatic › Repair and Diagnosis › Engine Performance › Engine Control System - 3.5L › DTC P1225: TP Sensor › DTC Confirmation Procedure › With Consult-II

With Consult-II

  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT-II.
  3. Turn ignition switch OFF, wait at least 10 seconds.
  4. Turn ignition switch ON.
  5. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
    Fig 1: CONSULT-II Diagnosis Function Display
    G02885843Courtesy of NISSAN MOTOR CO., U.S.A.
About FixVault