DTC Confirmation Procedure

NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 5 seconds before conducting the next test.

CAUTION: Always drive vehicle at a safe speed.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is more than 10V at idle.
This test may be conducted with the drive wheels lifted in the shop or by driving the vehicle. If a road test is expected to be easier, it is unnecessary to lift the vehicle.

WITH CONSULT-II

Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-II.
Start engine and maintain the following conditions for at least 5 consecutive seconds.

Fig 1: Reference Data
Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 2: Reading "VHCL SPEED SE" In "DATA MONITOR" Mode
Courtesy of NISSAN MOTOR CO., U.S.A.
If DTC is detected, go to "DIAGNOSTIC PROCEDURE ".

WITH GST

Follow the procedure "WITH CONSULT-II".