FixVault
Home › Nissan-Datsun › 2004 › Frontier Desert Runner SE › Repair and Diagnosis › Engine Performance › Engine Control System - VG33E › DTC P0510: Closed TP Switch › DTC Confirmation Procedure

DTC Confirmation Procedure

CAUTION: Always drive vehicle at a safe speed.
NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 5 seconds before conducting the next test.

WITH CONSULT-II 

  1. Start engine and warm it up to normal operating temperature.
  2. Turn ignition switch OFF, wait at least 10 seconds and then start engine.
  3. Select "CLSD THL/P SW" in "DATA MONITOR" mode.
  4. Check the signal under the following conditions.
    Fig 1: Reading "CLSD THL/P SW" In "DATA MONITOR" Mode
    G00743052Courtesy of NISSAN MOTOR CO., U.S.A.
    Fig 2: Reference Data
    G00743051Courtesy of NISSAN MOTOR CO., U.S.A.

    If the result is NG, go to "DIAGNOSTIC PROCEDURE ".

    If OK, go to following step.

  5. Select "DATA MONITOR" mode with CONSULT-II.
    Fig 3: Reading "MONITOR" In "DATA MONITOR" Mode
    G00743054Courtesy of NISSAN MOTOR CO., U.S.A.
  6. Drive the vehicle for at least 5 consecutive seconds under the following condition.
    Fig 4: Reference Data
    G00743053Courtesy of NISSAN MOTOR CO., U.S.A.
  7. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE "
About FixVault