With CONSULT-II

1. Turn ignition switch ON.
2. Select "EVAP SYSTEM CLOSE" of "WORK SUPPORT" mode with CONSULT-II.
3. Touch "START" and apply pressure into the EVAP line until the pressure indicator reaches the middle of the bar graph.
   NOTE:

   • Never use compressed air or a high pressure pump.
   • Do not exceed 4.12 kPa (0.042 kg/cm² , 0.6 psi) of pressure in the system.
   Fig 1: CONSULT-II Display Screen

   Courtesy of NISSAN MOTOR CO., U.S.A.
4. Using EVAP leak detector, locate the EVAP leak. For the leak detector, refer to the leak detector instruction manual for more details.

   Refer to "EVAPORATIVE EMISSION LINE DRAWING ".

OK or NG 

1. OK: GO TO 11.
2. NG: Repair or replace.

Fig 2: Typical Leak Detector

Courtesy of NISSAN MOTOR CO., U.S.A.