Diagnostic Procedure

1. Turn ignition switch OFF.
2. Disconnect ECM harness connector.
3. Check voltage between ECM terminal 121 and ground with CONSULT-II or tester.
   Fig 1: Checking Voltage Between Ecm Terminal 121 And Ground

   Courtesy of NISSAN MOTOR CO., U.S.A.

   Voltage: Battery voltage 

OK or NG 

1. OK: GO TO  3 .
2. NG: GO TO 2.

Check the following.

• IPDM E/R harness connector E124
• 15A fuse
• Harness for open or short between ECM and battery
  1. Repair or replace harness or connectors.

Refer to TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT  .

OK or NG 

1. OK: GO TO 4.
2. NG: Repair or replace harness or connectors.

With CONSULT-II 

1. Turn ignition switch ON.
2. Select "SELF DIAG RESULTS" mode with CONSULT-II.
3. Touch "ERASE".
4. Perform DTC Confirmation Procedure. 

   See DTC CONFIRMATION PROCEDURE  .

5. Is the 1st trip DTC P1065 displayed again?

With GST 

1. Turn ignition switch ON.
2. Select MODE 4 with GST.
3. Touch "ERASE".
4. Perform DTC Confirmation Procedure. 

   See DTC CONFIRMATION PROCEDURE  .

5. Is the 1st trip DTC P1065 displayed again?

Yes or No 

1. Yes: GO TO 5.
2. No: INSPECTION END 

1. Replace ECM.
2. Perform initialization of NATS system and registration of all NATS ignition key IDs. Refer to ECM RE-COMMUNICATING FUNCTION .
3. Perform ACCELERATOR PEDAL RELEASED POSITION LEARNING  .
4. Perform THROTTLE VALVE CLOSED POSITION LEARNING  .
5. Perform IDLE AIR VOLUME LEARNING  .
   1. INSPECTION END