Removal and Installation: Installation

WARNING: This page is about a different car, the 2004 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal. Refer to "POWER STEERING GEAR AND LINKAGE " and "POWER STEERING OIL PUMP " for tightening torque.
NOTE: Notice component parts location and do not reuse non-reusable parts.
Ensure that hose touches spool of tube when tube is to be inserted to hose.

Fig 1: Installing Hydraulic Line
Courtesy of NISSAN MOTOR CO., U.S.A.

CAUTION: Do not apply power steering fluid to the junction surface between tube and hose.
To install eye joint, join projection of eye joint into notch of power steering pump. Make sure eye joint to power steering pump is properly installed. Then, fully tighten eye bolt to a specified torque.
Connect harness connector into power steering pressure switch securely.

Fig 2: Installing Eye Joint with Torque Specs

Courtesy of NISSAN MOTOR CO., U.S.A.