Inspection Procedure

WARNING: This page is about a different car, the 2004 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.

CHECK SELF-DIAGNOSIS RESULT
Check self-diagnosis results.

Fig 1: Self-Diagnosis Results Chart
Courtesy of NISSAN MOTOR CO., U.S.A.

Is above displayed in self-diagnosis display items?
1. YES: GO TO 2.
2. NO: Inspection END
CHECK CONNECTOR
1. Disconnect the stop lamp switch connector E116 and ABS actuator and electric unit (control unit) connector E24 and check terminals for deformation, disconnection, looseness, and so on. If any malfunction is found, repair or replace terminal.
2. Securely reconnect connectors.
3. Start engine.
4. Repeat pumping brake pedal carefully several times, then perform self-diagnosis again.
OK or NG
1. OK: Connector terminal contact is loose, damaged, open or shorted.
2. NG: GO TO 3.
CHECK STOP LAMP SWITCH CIRCUIT
1. Turn ignition switch OFF and disconnect stop lamp switch connector E116 and ABS actuator and electric unit (control unit) connector E24.
2. Check continuity between stop lamp switch harness connector E116 and ABS actuator and electric unit (control unit) harness connector E24.
  
  Fig 2: Checking Continuity Between Stop Lamp Switch Harness Connector E116 And ABS Actuator And Electric Unit Harness Connector E24
  Courtesy of NISSAN MOTOR CO., U.S.A.
  
  Fig 3: ABS Actuator And Electric Unit Chart
  Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
1. OK: Connect connectors and conduct a ABS actuator and electric unit (control unit) self-diagnosis.
2. NG: Open or short in harness. Repair or replace harness.