Odo/Trip Meter and Illumination Control Switch Inspection

WARNING: This page is about a different car, the 2004 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.

CHECK ODO/TRIP METER AND ILLUMINATION CONTROL SWITCH

Remove combination meter. Refer to "REMOVAL AND INSTALLATION OF COMBINATION METER ".
Remove meter lid. Refer to "DISASSEMBLY AND ASSEMBLY OF COMBINATION METER ".

Check continuity between odo/trip meter and illumination control switch harness connector M303 terminals 3, 4 or 5 and 6.

CONTINUITY CHECK CHART

Terminal		Condition	Continuity
3	6	Illumination control switch (+) is pushed.	Yes
3		Illumination control switch (+) is released.	No
4		Illumination control switch (-) is pushed.	Yes
4		Illumination control switch (-) is released.	No
5		Odo/trip meter switch is pushed.	Yes
5		Odo/trip meter switch is released.	No

Fig 1: Checking Continuity Between Odo/Trip Meter And Illumination Control Switch Harness Connector Terminals

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: Replace combination meter.
NG: Replace odo/trip meter and illumination control switch.