FixVault
Home › Nissan-Datsun › 2004 › Sentra SE-R › Repair and Diagnosis › External Pages › Different car › Section 1413 (Automatic Air Conditioner) › Trouble Diagnosis › Intake Sensor Circuit › Diagnostic Procedure For Intake Sensor

Diagnostic Procedure For Intake Sensor

WARNING: This page is about a different car, the 2005 Infiniti FX45 and 2005 Infiniti FX35. However, it is still accessible from the selected car via links, so may be relevant.

SYMPTOM: Intake sensor circuit is open or shorted. (24 or -24 is indicated on unified meter and A/C amp. as a result of performing Self-diagnosis STEP-2.)

Fig 1: Intake Sensor Circuit
G02364684Courtesy of NISSAN MOTOR CO., U.S.A.
  1. CHECK VOLTAGE BETWEEN INTAKE SENSOR AND GROUND 
    1. Disconnect intake sensor connector.
    2. Turn ignition switch ON.
    3. Check voltage between intake sensor harness connector M254 terminal 2 (R) and ground.
      1. 2 - Ground: Approx. 5V 

    OK or NG 

    1. OK: GO TO 2.
    2. NG: GO TO  4.
    Fig 2: Checking Voltage Between Terminal 2 And Ground
    G02364685Courtesy of NISSAN MOTOR CO., U.S.A.
  2. CHECK CIRCUIT CONTINUITY BETWEEN INTAKE SENSOR AND UNIFIED METER AND A/C AMP. 
    1. Turn ignition switch OFF.
    2. Disconnect unified meter and A/C amp. connector.
    3. Check continuity between intake sensor harness connector M254 terminal 1 (W) and unified meter and A/C amp. harness connector M57 terminal 49 (W/G).
      1. 1 - 49: Continuity should exist. 

    OK or NG 

    1. OK: GO TO 3.
    2. NG: Repair harness or connector.
    Fig 3: Checking Continuity Between Terminal 1 And Terminal 49
    G02364686Courtesy of NISSAN MOTOR CO., U.S.A.
  3. CHECK INTAKE SENSOR 

    Refer to "INTAKE SENSOR ".

    OK or NG 

    1. OK :
      1. Replace unified meter and A/C amp.
      2. Go to self-diagnosis "FUNCTION CONFIRMATION PROCEDURE " and perform self-diagnosis STEP-2. Confirm that code No. 20 is displayed.
    2. NG :
      1. Replace intake sensor.
      2. Go to self-diagnosis "FUNCTION CONFIRMATION PROCEDURE " and perform self-diagnosis STEP-2. Confirm that code No. 20 is displayed.
  4. CHECK CIRCUIT CONTINUITY BETWEEN INTAKE SENSOR AND UNIFIED METER AND A/C AMP. 
    1. Turn ignition switch OFF.
    2. Disconnect unified meter and A/C amp. connector.
    3. Check continuity between intake sensor harness connector M254 terminal 2 (R) and unified meter and A/C amp. harness connector M57 terminal 41 (P).
      1. 2-41: Continuity should exist. 
    4. Check continuity between intake sensor harness connector M254 terminal 2 (R) and ground.
      1. 2 - Ground: Continuity should not exist. 
    Fig 4: Checking Continuity Between Terminal 2 And Ground
    G02364687Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    1. OK :
      1. Replace unified meter and A/C amp.
      2. Go to self-diagnosis "FUNCTION CONFIRMATION PROCEDURE " and perform self-diagnosis STEP-2. Confirm that code No. 20 is displayed.
    2. NG: Repair harness or connector.
About FixVault