FixVault
Home › Nissan-Datsun › 2004 › Sentra SE-R › Repair and Diagnosis › External Pages › Different car › Section 1450 (Glass, Window System & Mirrors) › Power Window System › Drive Side Power Window Motor Circuit Check

Drive Side Power Window Motor Circuit Check

WARNING: This page is about a different car, the 2005 Nissan 350Z. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK POWER WINDOW MAIN SWITCH OUTPUT SIGNAL 
    1. Turn ignition switch ON.
    2. Power window main switch operate, check voltage between driver side power window motor connector and ground.
      Fig 1: Driver Side Power Window Motor Connector & Ground Voltage Specifications Table
      G02404627Courtesy of NISSAN MOTOR CO., U.S.A.
      Fig 2: Driver Side Power Window Motor Connector & Ground Voltage Test
      G02404628Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    • OK: Replace driver side power window motor.
    • NG: GO TO 2.
  2. CHECK POWER WINDOW MAIN SWITCH CIRCUIT 
    1. Turn ignition switch OFF.
    2. Disconnect power window main switch and driver side power window motor connector.
    3. Check continuity between power window main switch connector D7 terminals 8, 11 and driver side power window motor connector D9 terminals 1, 2.
      • 8(L) - 2 (L): Continuity should exist. 
      • 11 (G) - 1 (G): Continuity should exist. 
      Fig 3: Power Window Main Switch Connector Terminals Continuity Test
      G02404629Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    • OK: Further inspection is necessary. Refer to symptom chart.
    • NG: Repair or replace harness.
About FixVault