Door Mirror Remote Control Switch Ground Circuit Inspection

WARNING: This page is about a different car, the 2005 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.

CHECK DOOR MIRROR REMOTE CONTROL SWITCH GROUND CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect door mirror remote control switch.
3. Check continuity between door mirror remote control switch connector D10 terminal 7 and ground.
  13 (B) - Ground : Continuity should exist .
OK or NG
- OK : GO TO 2.
- NG : Repair or replace harness.

CHECK DOOR MIRROR REMOTE CONTROL SWITCH (CHANGEOVER SWITCH)

Check continuity between door mirror remote control switch as follows.

Fig 2: Checking Continuity Between Door Mirror Remote Control Switch

Courtesy of NISSAN MOTOR CO., U.S.A.

CONTINUITY BETWEEN DOOR MIRROR REMOTE CONTROL SWITCH REFERENCE

Connector	Terminals		Condition	Continuity
D10	3	13	Changeover switch RIGHT position	Yes
	3		Other than above	No
	2		Changeover switch LEFT position	Yes
	2		Other than above	No

OK or NG

OK : Check the condition of the harness and the connector.
NG : Replace door mirror remote control switch.